![]() ![]() ![]() ![]() Thanks so much in advance for any advice. Sold by kjdElectronics and ships from Amazon Fulfillment. In the IDE the adafruit package only contains the Trinket 5V, which I select for compiling and uploading the sketch, this cannot have something to do with it right? Adafruit Pro Trinket LiIon/LiPoly Backpack Add-On. So this shouldnt be a problem in the first place. USB bootloader with a nice LED indicator looks just like a USBtinyISP so you can. Maximum current I measured was around 100 mA, as expected from the datasheet. Thats why Adafruit designed Pro Trinket, with 18 GPIO, 2 extra analog. I measured the voltage of the Adafruit trinket outputs to be close to the expected 5V. The displayed current never goes above 8mA. ATmega328P onboard chip in QFN package running at 3.3V logic 12MHz clock rate, 28K FLASH available USB bootloader with a nice LED indicator looks just like a. If I use an external 5V power supply to simulate the signal output (istead of the trinket), everything in the circuit works fine. I'm powering the trinket via an external 12V, 3A power supply connected to the "Battery" Pin. In fact, the Relais does not work anymore at all and the LEDs are much darker, just barely noticable. I just want to control a Relais and some status LEDs.Īnd yet it seems like the digital out signals do not supply enough power to run the circuit properly. I'm having trouble shrinking a project of mine from Arduino Uno to an Adafruit Pro Trinket 12V. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |